→ Waterproofing → IZOWEL ELASTIC POLYMER CEMENT WATERPROOFING

IZOWEL ELASTIC POLYMER CEMENT WATERPROOFING

Range of Application.
IZOWEL dry polymer-cement mix is used for waterproofing:
- operated roofs, balconies, veranda, pools, tanks;
- panel joints of building structures;
- surfaces subject to dynamic loads.
IZOWEL protects metals against corrosion;
IZOWEL waterproof mix possesses high adhesion to concrete, plastered, brick, timber, gypsum plasterboard, and metallic surfaces.

Temperature Conditions.
Work should be done at a temperature no lower than +5°C.

Pack.
IZOWEL is delivered powdered, in 12kg buckets.

Storage.
IZOWEL should be stored in dry premises, inside the Manufacturer's packs. Maximum stock height for storage and shipping is 3 buckets. In the case of damage to the Manufacturer's pack or the remainder of dry material after work, pour the material into the sealed container.

Storage Period.
12 months from the date of manufacturing, inside intact Manufacturer's packs.

Safety and Labor Protection.
When treating the operating mix it is necessary to wear rubber gloves, protective breathing equipment, and protective goggles. Rubber gloves should be worn when applying the IZOWEL mix solution. In case of contact with skin or eyes the affected areas should be washed with a large amount of water.

Waste Disposal.
Waste disposal of IZOWEL diluted mix should be performed in conformity with regulations and requirements to cement contained material disposal. It is strictly forbidden to throw material remains in the sewerage system or to bury them in soil.

Way of use:

1. Surface requirements. 
The surface must be dry and free of dust. 

2. Mortar preparation, and Applying on Surface.
Add 350-400 ml of water (t=18-25°C) to 1 kg of IZOWEL. Agitate carefully for 3-5 minutes using an electric drilling machine equipped with the blending bit (or mixer) to obtain a homogeneous and plastic mix solution. Apply the finished mix on surfaces using a brush. Just after application, lay the glass fabric (from the pack) upon the first coating. Thereby IZOWEL mortar must penetrate into the cells of the glass fabric.
After the first coating has dried completely, apply the second coating until the glass fabric is covered completely. Material consumption per a single coating is 1.5 kg per sq.m.

3. Further exploitation of Waterproof Coating.
When the second coating is completely dry the surface may be used as a base for decorative tiles, parquet, paints, and plaster, etc.

4. Temperature Conditions.
Work should be done at a temperature no lower than +5°C.